Project Blue Ice @ ReviewNation

I don't post case mods very often but every once in awhile something comes along that just needs a mention.
"Well I had a little bit different plans of mounting this window than it would appear, and what is most common among modders. I taped around the edge of the window again, and measured out 4 holes (evenly spaced) along the top and bottom, and 3 holes (evenly spaced) along the sides. I then took my plexi window and mounted it on the back of the panel with double sided sticky tape. After the plexi was mounted, I drilled holes where I had previously marked, so it would go through both the panel and the window. "
This sounds more like a OEM/Pre-modded solution than a common modders solution. I think you will understand once you see the completed window. I will say that they did a nice job with the detailing.

Related Web URL: http://www.reviewnation.com/blueice/index.shtml